Sensor Batteries; Tire Pressures; Replacement Tires - Triumph Street Cup Owner's Handbook Manual

Hide thumbs Also See for Street Cup:
Table of Contents

Advertisement

General Information
When the tire pressure monitoring
system has been selected, —— PSI or
bAr is shown in display screen until the
motorcycle is traveling at a speed
greater than 12 mph (20 km/h) and the
tire pressure signal is received.
To exit the tire pressure display, press
and release the SCROLL button until the
desired display screen is shown.

Sensor Batteries

When the battery voltage in a pressure
sensor is low, LO bAt will be displayed
and the TPMS symbol will indicate which
wheel sensor has the low battery
voltage. If the batteries are completely
flat, only dashes will be visible in the
display screen, the red TPMS warning
light will be on and the TPMS symbol will
flash
continuously.
authorized Triumph dealer to have the
sensor replaced and the new serial
number recorded in the spaces provided
on page 45.
With the ignition switch turned to the
ON position, if the TPMS symbol flashes
for 10 seconds and then remains on
there is a fault with the TPMS system.
Contact your authorized Triumph dealer
to have the fault rectified.
46
Contact
your

Tire Pressures

Warning
The tire pressure monitoring system is
not to be used as a tire pressure
gauge
when
pressures. For correct tire pressures,
always check the tire pressures when
the tires are cold using an accurate
tire pressure gauge (see page 143).
Use of the TPMS system to set
inflation
pressures
incorrect tire pressures leading to loss
of motorcycle control and an accident.
The tire pressures shown on your
instrument panel indicate the actual
tire pressure at the time of selecting
the display. This may differ from the
inflation pressure set when the tires are
cold because tires become warmer
during riding, causing the air in the tire
to expand and the inflation pressure to
increase. The cold inflation pressures
specified by Triumph take account of
this.
Only adjust tire pressures when the
tires are cold using an accurate tire
pressure gauge (see page 120). Do not
use the tire pressure display on the
instruments.

Replacement Tires

When replacing tires, always have an
authorized Triumph dealer mount your
tires and make sure they are aware that
tire pressure sensors are installed to
the wheels.
adjusting
the
may
lead
tire
to

Advertisement

Table of Contents
loading

Table of Contents