NEC Univerge SV8100 Programming Manual page 337

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
UNIVERGE SV8100
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit . . .
Input Data
Item
No.
01
02
03
04
Programming Manual
When you want to. . .
0 Enter characters:
0 !
Enter characters:
+
# = Accepts an entry (only required if two letters on the same key
#
are needed - ex: TOM). Pressing # again = Space.
(In system programming mode, use the right arrow soft key
instead to accept and/or add a space.)
CONF Clear the character entry one character at a time.
HOLD Clear all the entries from the point of the flashing cursor and to the
right.
Conversion Table Number
Item
Received Number
This is the received DID digits.
Target Number
Enter the destination number to which the
DID number is sent.
DID Name
This is the name that is assigned to the
DID digits when it rings the extension.
Transfer Operation Mode
Key for Entering Names
" # $ % & ' (
, - . / : ; < =
Input Data
Maximum 8 digits
Maximum 24 digits
Maximum 12 characters
0 = No Transfer
1 = Busy
2 = No Answer
3 = Busy/No Answer
Issue 1.0
) ô Õ ú ä ö ü
?
>
1~2000
Default
No Setting
No Setting
No Setting
0
2 - 303
¢ £