Program 34 : Tie Line Setup; E&M Tie Line Basic Setup - NEC Univerge SV8100 Programming Manual

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
Level:
IN
Description
Use Program 34-01 : E&M Tie Line Basic Setup to define the basic settings
for each E&M Tie line.
Input Data
Item
Item
No.
01
DID/E&M Start
Signaling
02 Receive Dial Type
for E&M Tie Line
03 E&M Dial-In Mode
04
E&M Line Dial Tone
05
System Toll
Restriction
Programming Manual

Program 34 : Tie Line Setup

34-01 : E&M Tie Line Basic Setup
Trunk Port Number
Input Data
nd
0 = 2 Dial Tone
1 = Wink
2 = Immediate
3 = Delay
0 = DP
1 = DTMF
2 = MF
0 = Specify Extension
Number
(Intercom)
1 = Use Conversion
Table (NTT)
0 = Disable (No)
1 = Enable (Yes)
0 = No (Off)
1 = Yes (On)
001~200
Default Description
1 Set the start signaling mode for
DID and Tie trunks. DID and
Tie trunks can use either
immediate start or wink start
signaling.
1
0 Determine if the incoming Tie
Line call should be directed as
an intercom call or if it should
follow the DID Translation
Table in Program 22-11.
1 Enter 1 if the Tie Line should
send dial tone to the calling
system after the call is set up.
Enter 0 if the Tie Line should
not send dial tone.
0 Determine if an incoming Tie
Line call should be subject to
Toll Restriction.
Program
34
Related
Program
22-02
10-09
22-11
21-05
2 - 391