NEC Univerge SV8100 Programming Manual page 435

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
UNIVERGE SV8100
Item
No.
04
Route Table Setup of Target Dial
The option sets how the system uses the
route data (gathered in Item 3) to route
incoming ANI/DNIS calls.
If option 2 is selected, and the call is to be
routed using the DID table (1), up to 8 digits
can be matched. The number of expected
digits set in Program 22-09-01 must match the
ANI digits defined in Program 22-11-01. For
example, if an ANI/DNIS number received
was 2035551234 3001 and Program
22-09-01=4, the entry in 22-11-01 must be
1234 with the defined target extension.
If the call is to be routed using the ABB table
(0), up to 24 digits can be matched. Define the
range of the ABB table to be used in Program
34-09-06. The data is compared to the entries
in Program 13-04-01 and then routed
according to Program 13-04-03.
05
ANI/DNIS Display as Target Dial Name
Use this option to set whether or not ANI data
should appear on telephone displays as part
of Caller ID display.
06
Routing SPD Table Setup
Use this option to define which part of the ABB
Table set up in Program 13-04 the system
uses for ANI/DNIS Caller ID look-ups and ANI/
DNIS routing.
This is required if Items 4 and 5 above are 1
(Caller ID on). When you specify a starting
and end address, the system uses the part of
the table for look-ups.
When you specify a starting address and
length, the system uses that part of the table
for routing. If the incoming ANI/DNIS number
data matches the Number entry in the table,
the system routes according to the associated
Name data. That data can be an extension,
Department Group pilot number, the voice
mail master number or a trunk ring group.
07
Routing on ANI/DNIS Error
This option lets you determine how the system
handles an ANI/DNIS call if a data error is
detected in the incoming data string.
Programming Manual
Name Input Data
0 = SPD Table
(Program 13-03)
1 = DID Table
(Program 22-11)
0 = Display Off
1 = Display On
Start = 0, 100~1900
End = 0, 99~1999
0 = Play Busy Tone to
Caller
1 = Route Caller to Ring
Group Specified in
Program 25-03
(Transfer)
Issue 1.0
Default
Related
Program
COS 2~15
0 13-04-01
13-04-03
22-09-01
22-11
34-09-05
34-09-06
0 13-04
20-09-02
22-11-03
23-09-04
Start = 0 13-04
End = 0
0 25-03
2 - 401