Dial Analysis Table For Ars/F-Route Access - NEC Univerge SV8100 Programming Manual

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
Issue 1.0

44-02 : Dial Analysis Table for ARS/F-Route Access

Level:
IN
Description
Use
Pre-Transaction Table for selecting ARS/F-Route.
Input Data
Item
No.
01
02
2 - 466
Program 44 : ARS/F-Route Setup
Program 44-02 : Dial Analysis Table for ARS/F-Route Access
Dial Analysis Table Number
Item
Dial
Set the number of digits to be analyzed by the
system for ARS routing.
Service Type
Service Type 1 (Extension Number)
The number goes to an extension after
deleting the front digit(s).
Additional Data
Assign the digit(s) to be deleted on top of the
number for extension number usage. At least
one digit must be deleted.
Service Type 2 (ARS/F-Route)
The number is controlled by ARS/F-Route
table.
Additional Data:
If the ARS/F-Route Time Schedule is not
used, assign the ARS/F-Route table number
for Program 44-05.
If the ARS/F-Route Time Schedule is used,
assign the ARS/F-Route selection number for
Program 44-04.
Service Type 3 (Dial Extension Analyze
Table)
The total length of the number exceeds more
than 8 digits.
Additional Data:
Assign the Dial Extension Analysis Table
number to be used in Program 44-03.
UNIVERGE SV8100
to set the
1~120
Input Data
Up to eight digits
(Use line key 1 for a Don't
Care digit, @)
0 = No setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Analyze
Table (Option)
Program 44 : ARS/F-Route Setup
Default
No
Setting
0