Tie Line Initial Setup - NEC Univerge SV8100 Programming Manual

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
Issue 1.0
Program 81 : Basic Hardware Setup for Trunk
Level:
IN
Description
Use Program 81-11 : Tie Line Initial Setup to define the various initial data for DID/
TLI/DTI packages.
Input Data
Item
No.
01
02
03
04
2 - 626
Trunk No.
Item
DP Interdigit Time Selection
The DP Interdigit Time is the minimum
pause time between dial pulses. Use this
Program to select either Pattern A or
pattern B.
Prepause Time Selection
Specifies the loop open time for a hookflash
signal sent to the Tie Line when the Recall
key on a multiline terminal is pressed. A
Single Line Telephone (SLT) generates a
hookflash to the Tie Line when a SLT
hookflash is assigned.
Tie Line Answer Detect Time Selection
Specifies the time before a UNIVERGE
SV8100 system answer (Off-Hook) is
recognized as an answer.
Tie Line Release Detect Time Selection
Specifies the circuit disconnect detected on
the Tie Line on the distant system side is
recognized as Tie Line.

81-11 : Tie Line Initial Setup

1~ 200
Input Data
0 = Pattern A
(Pattern A: 10pps – 650ms,
20pps – 500ms)
1 = Pattern B
(Pattern B: 10pps – 800ms,
20pps – 800ms)
1~4
(1~4 = 0.5~2.0 seconds)
(5~15 = 3.0~13 seconds)
(0 = No Setting)
0~15
(130ms~1950ms)
(0 = No Setting)
0~15
(130ms~1950ms)
(0 = No Setting)
Program 81 : Basic Hardware Setup for Trunk
UNIVERGE SV8100
Default
1
0
(No Setting)
4
(520ms)
4
(520ms)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents