NEC Univerge SV8100 Programming Manual page 411

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
UNIVERGE SV8100
When entering names in the procedures below, refer to this chart. Names can have up to
Input Data
Item
No.
01
Default
Item 01 : Internal Paging Group Name
Programming Manual
Use this keypad
digit . . .
# # = Accepts an entry (only required if two letters on the same key
are needed - ex: TOM). Pressing
programming mode, use the right arrow soft key instead to accept
and/or add a space.)
Conf Clear the character entry one character at a time.
Hold Clear all the entries from the point of the flashing cursor and to the
right.
Internal Paging Group Number
Internal Paging Group Name
Assign name to Internal Paging Groups (i.e., Page
Zones). The system shows the name you program on the
telephone display.
Extension
Name
Paging Group
01 Group 1
02 Group 2
:
64 Group 64
Key for Entering Names
12 digits.
When you want to. . .
Item
:
Issue 1.0
# again = Space. (In system
01~64
Input Data Default
Up to 12 Characters Refer to
default
table.
2 - 377