NEC Univerge SV8100 Programming Manual page 198

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
Issue 1.0
Item
No
06
07
08
09
10
11
14
15
16
2 - 164
Item
Extension Polarity Reverse
Not Used in U.S. --
Do Not Change Default Entry as DTMF issues
may arise with voice mail.
Enabled On-Hook When Holding (SLT)
Answer On-Hook when Holding (SLT)
Caller ID Function - For External Module
Enable (1) or disable (0) the Caller ID FSK signal
for an external Caller ID module or a 3rd party
vendor telephone with Caller ID display.
Important:
If voice mail is used, this setting must be
disabled for the system integration codes to be
correct.
With a 2500 set (no Caller ID) installed, this
must be set to 0 for incoming callers to have a
talk path.
Caller ID Name
Determine if an extension user telephone should
display the Caller ID name.
Caller ID Type
Determine whether the Caller ID type is FSK or
DTMF.
Forwarded Caller ID Display Mode
Determine what the display shows when a
multiline terminal receives a forwarded outside
call.
Disconnect without dial after hooking hold
Determine whether or not to disconnect a held
call when on-hook without any dialing after
hooking-hold.
Special DTMF Protocol Send
Determine whether or not to send the extension
number of the phone forwarded to the extension
when PRG 15-03-04 is set to Special (1) and not
in the VM group.
UNIVERGE SV8100
Input Data Default
0 = Disable 0
(Off)
1 = Enable
(On)
0 = No 1
1 = Yes
0 = Disable 1
(No)
1 = Yes
(Enable)
0 = Disable 0
(Off)
1 = Enable
(On)
0 = Disable 1
1 = Enable
0 = FSK 0
1 = DTMF
0 = Calling 0
Extension
Number
(Calling)
1 = External
Caller ID
(Forward)
0 = Normal 0
1 = Disc.
0 = No 0
1 = Yes
Program 15 : Extension, Basic Setup
Related
Program
11-12-45
11-12-46
15-03-09