NEC Univerge SV8100 Programming Manual page 78

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
Issue 1.0
Input Data
Conditions
None
Feature Cross Reference
None
2 - 44
05
Domain Assignment
If the information from
Telco was a domain
name
(siptrunk@sip.com)
then set to domain. If
the information for
Telco was a IP address
then set to IP Address.
06
IP Trunk Port
Binding
Trunk port binding is
only used for SIP trunks
to the provider in "Non-
Registration Mode
only". When this is
disabled, an inbound
call comes in and
follows your DID routing
but it comes in on the
first available trunk.
When enabled, the
inbound call comes in
and follows your normal
DID routing but maps to
that specified trunk. If
that trunk is busy, we
will send back a busy
unless you build a hunt
group. To build the
hunt group, it
references command
14-12-02 (pilot register
ID). This then points
you to command 10-36-
02. All the numbers
with the same pilot
would be in the same
hunt group.
0 = IP Address
1 = Domain Name
0 = Disable
1 = Enable
Program 10 : System Configuration Setup
UNIVERGE SV8100
0
0