NEC Univerge SV8100 Programming Manual page 173

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
UNIVERGE SV8100
Item
No.
06
07
08
09
10
11
12
Programming Manual
Item
Pause at 1st Digit after Line Seize in
Manual Dial Mode
DP to DTMF Conversion Options
Determine how a user can convert a
Dial Pulse (DP) call to a DTMF call. For
each trunk, set the type of DP to DTMF
conversion required. There are three
conversion options: Automatic (0),
Automatic and Manual (1), or Manual
(2).
Automatic:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit.
Automatic and Manual:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit. In addition, the
#
user can dial to switch a DP trunk to
DTMF dialing.
Manual:
#
Users can dial to switch a DP trunk
to DTMF dialing.
Answering Condition
Busy Tone Detection
Caller ID
Enable or disable a trunk to receive
Caller ID information.
Next Trunk in Rotary if No Dial Tone
Use this option to enable/disable the
system ability to skip over a trunk if dial
tone is not detected. This option
pertains to calls placed using Speed
Dial, ARS, Last Number Redial or
Save Number dialed. It does not
pertain to line key or Direct Trunk
Access calls.
Detect Network Disconnect Signal
Input Data
0 = No Pause (No)
1 = Pause (Yes)
0 = Automatic
1 = Automatic and
Manual
2 = Manual
0 = Polarity
Reversing
(Polarity)
1 = Polarity
Reversing or
Timer (Int Digit)
0 = Disable (No)
1 = Enable (Yes)
0 = No
1 = Yes
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
Issue 1.0
Related
Default
Program
1 21-01-06
2 21-01-03
1 21-01-03
0
0
0
1
2 - 139