Single Line Telephone Basic Data Setup - NEC Univerge SV8100 Programming Manual

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
UNIVERGE SV8100
Level:
IN
Description
Use Program 15-03 : Single Line Telephone Basic Data Setup to set up various
single line telephone options.
Input Data
Item
No
01
03
04
05
Programming Manual
Program 15 : Extension, Basic Setup

15-03 : Single Line Telephone Basic Data Setup

Extension Number
Item
SLT Signaling Type
Use this option to tell the system the type of
dialing the connected telephone uses.
For the UNIVERGE SV8100 Wireless
telephones to function correctly, this must be set
to 0 (dial pulse). If this option is set for DTMF,
after an outside call is placed, the system cannot
dial any additional digits.
This program change is automatically performed
when the UNIVERGE SV8100 Wireless
telephone is registered. When upgrading
software from prior versions, the previous default
of 1 is saved from the prior database so this
option must be changed manually.
Terminal Type
Enter 1 for this option to allow a single line port
to receive DTMF tones after the initial call setup.
Enter 0 to have the port ignore DTMF tones after
the initial call setup. For Voice Mail, always enter
1 (e.g., receive DTMF tones).
Flashing
Enables/disables Flash for single line (500/2500
type) telephones.
Trunk Polarity Reverse
Not Used in U.S. – Do Not Change Default Entry
as DTMF issues may arise with voice mail.
Maximum eight digits
Input Data Default
0 = DP 1
1 = DTMF
0 = Normal 0
1 = Special
0 = No 1
1 = Yes
0 = Off 0
1 = On
Issue 1.0
Related
Program
15-03-03
45-01-01
15-03-01
45-01-01
2 - 163