NEC Univerge SV8100 Programming Manual page 190

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
Issue 1.0
Item
No.
03
04
05
06
07
08
10
2 - 156
Item
Extension Ring Tone
Use this option to set the tone
(pitch) of the incoming extension
call ring for the extension port you
are programming. Also refer to
Program 15-08.
DTU/DTP style telephones only
follow high, medium and low
range ring tone settings. They do
not follow Melodies.
Redial (Speed Dial) Control
Use this option to control the
function of the extension Redial
key when used with Speed Dialing.
The Redial key can access either
the Common or Group Speed
Dialing numbers.
Transfer Key Operation Mode
Use this option to set the operating
mode of the extension CONF key.
The keys can be for Call Transfer,
Serial Calling or Flash. When
selecting the Flash option
(selection 2), refer also to Program
81-01-14.
Hold Key Operating Mode
Use this option to set the function
of the Multiline Hold key. The Hold
key can activate normal Hold or
Exclusive Hold.
Automatic Hold for CO Lines
When talking on a CO call and
another CO line key is pressed, the
original trunk is placed on Hold (0)
or Disconnected (1).
Automatic Handsfree
Use this option to set whether
pressing a key accesses a
One-Touch Key or if it preselects
the key.
Ringing Line Preference for
Trunk Calls
Use this option to select between
Idle and Ringing Line Preference
for trunk calls.
Input Data
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
0 = Common and Individual
Speed Dialing
1 = Group Speed Dialing
0 = Transfer
1 = Call back
2 = Hook
0 = Normal (Common)
1 = Exclusive Hold
0 = Hold
1 = Disconnect (Cut)
0 = Preselect
1 = One-Touch (Automatic
Handsfree)
0 = Idle (Off)
1 = Ringing (On)
Program 15 : Extension, Basic Setup
UNIVERGE SV8100
Related
Default
Program
8
0
0
0
1
1
1