NEC Univerge SV8100 Programming Manual page 238

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
Issue 1.0
Input Data (Continued)
Item
Item
No.
09
Disconnect Supervision
Use this option to enable or disable
disconnect supervision for the system
trunks.
10
Time Before Shifting to
Power-Saving Mode
11
Handsfree Microphone Control
Use this option to control the setting
for Multiline Terminal Handsfree
microphone after being disconnected
and reconnected. If set to 0, the
microphone is always off when the
terminal is reconnected. If set to 1,
the microphone remains in the same
state it was in when the terminal is
reconnected.
12
Forced Intercom Ring (ICM Call
Type)
Use this option to enable or disable
Forced Intercom Ringing. If enabled,
incoming Intercom calls normally ring.
If disabled, Intercom calls
voice-announce.
13
--- Not Used ---
15
Caller ID Display Mode
18
Dialing Record Display Time
19
Virtual Extension Mode
Sets the mode of a virtual extension
key that appears on a DSS console.
2 - 204
Input Data
0 = Disable (Off)
1 = Enable (On)
0 = No shift
1 = 1 minute
2 = 2 minutes
3 = 4 minutes
4 = 8 minutes
5 = 16 minutes
6 = 32 minutes
7 = 64 minutes
0 = Off
1 = On
0 = Disable (Voice)
1 = Enable (Signal)
0 = Name and Number (Both)
1 = Name
2 = Number
0~64800 seconds
0 = No
1 = Yes
UNIVERGE SV8100
Default
Programming
1
0 15-02-18
1
0
0
30
0
Program 20 : System Option Setup
Related