Show Mls Qos Vlan - Cisco Catalyst 2960 Command Reference Manual

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

show mls qos vlan

Use the show mls qos vlan user EXEC command to display the policy maps attached to a switch virtual
interface (SVI).
Syntax Description vlan-id
| begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2(25)FX
Usage Guidelines
The output from the show mls qos vlan command is meaningful only when VLAN-based quality of
service (QoS) is enabled and when policy maps are configured.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples
This is an example of output from the show mls qos vlan command:
Switch> show mls qos vlan 10
Vlan10
Attached policy-map for Ingress:pm-test-pm-2
Related Commands Command
policy-map
OL-8604-04
show mls qos vlan vlan-id [ | {begin | exclude | include} expression]
Specify the VLAN ID of the SVI to display the policy maps. The range is 1 to
4094.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Description
Creates or modifies a policy map that can be attached to
multiple ports and enters policy-map configuration mode.
Catalyst 2960 Switch Command Reference
show mls qos vlan
2-423