Show Controllers Utilization - Cisco Catalyst 2950 Command Reference Manual

show controllers utilization

show controllers utilization
Use the show controllers utilization user EXEC command to display bandwidth utilization on
the switch or specific ports.
Syntax Description interface-id
| begin
| exclude
| include
expression
Command Modes
User EXEC
Command History Release
12.1(22)EA1
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show controllers utilization command.
Switch> show controllers utilization
Port
Fa0/1
Fa0/2
<output truncated>
Total Ports : 12
Switch Receive Bandwidth Percentage Utilization
Switch Transmit Bandwidth Percentage Utilization : 0
Switch Fabric Percentage Utilization : 0
This is an example of output from the show controllers utilization command on a specific port:
Switch> show controllers fastethernet0/1 utilization
Receive Bandwidth Percentage Utilization
Transmit Bandwidth Percentage Utilization
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-320
show controllers [interface-id] utilization [ | {begin | exclude | include} expression]
(Optional) ID of the switch interface.
(Optional) Display begins with the line that matches the specified expression.
(Optional) Display excludes lines that match the specified expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Receive Utilization
0
0
Chapter 2
Transmit Utilization
0
0
: 0
: 0
: 0
Catalyst 2950 and 2955 Cisco IOS Commands
0L-10102-01