Configuring Ancp Server Sender Name - Cisco ASR 9000 Series Service Configuration Manual

How to Configure ANCP on Cisco ASR 9000 Series Routers
Command or Action
Step 3
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config-an
cp)# end
or
RP/0/RSP0/CPU0:router(config-an
cp)# commit
Step 4
show ancp summary
[statistics][detail]
Example:
RP/0/RSP0/CPU0:router# show
ancp summary

Configuring ANCP Server Sender Name

The ANCP server sender name is used by the ANCP server in adjacency protocol messages to DSLAMs.
SUMMARY STEPS
1.
2.
3.
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
QC-96
configure
ancp server sender-name {H.H.H | A.B.C.D}
end
or
commit
Configuring Access Node Control Protocol on Cisco ASR 9000 Series Routers
Purpose
Saves configuration changes.
• When you issue the end command, the system prompts you
to commit changes:
Uncommitted changes found, commit them before
exiting (yes/no/cancel)?
[cancel]:
– Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
Entering no exits the configuration session and returns
–
the router to EXEC mode without committing the
configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or committing the
configuration changes.
Use the commit command to save the configuration changes
•
to the running configuration file and remain within the
configuration session.
(Optional) Displays ANCP summary and general configuration
information.
OL-23108-02