3Com V7122 User Manual page 373

Hide thumbs Also See for V7122:
Table of Contents

Advertisement

(local AND remote). Note that this alarm is raised for any change in the remote or local
congestion status.
acDChannelStatus – Non alarm trap sent at the establishment, re-establishment or
release of LAPD link with its peer connection. The trap is sent out with one of the
following textual descriptions:
D-channel synchronized
D-channel not-synchronized
In addition to the listed traps, the device also supports the following standard traps:
Proprietary Traps Description
Table 73
Trap
acBoardFatalError
acBoardConfigurationError
acBoardTemperatureAlarm
acBoardEvResettingBoard
acBoardEvBoardStarted
acgwAdminStateChange
acOperationalStateChange
acBoardCallResourcesAlarm
acBoardControllerFailureAlarm
acFeatureKeyError
acBoardOverloadAlarm
acActiveAlarmTableOverflow
acKeepAlive
V7122 Gateway User Guide
Description
Sent whenever a fatal device error occurs.
Sent when a device's settings are illegal. The trap contains a
message describing the illegality of the setting.
Note: Not applicable to IPM-260).
Sent when a board exceeds its temperature limits.
Sent after the device is reset.
Sent after the device is successfully restored and initialized
following reset.
Sent when Graceful Shutdown commences and ends.
Sent if the operational state of the node changes to disabled.
Cleared when the operational state of the node changes to
enabled.
Sent when no free channels are available.
Sent when the Gatekeeper/Proxy is not found or registration
failed. Internal routing table can be used for routing.
Intended to relay Feature Key errors etc. (will be supported in the
next applicable release).
Sent when an overload in one or more of the system's
components occurs.
Sent to indicate that an active alarm could not be entered into the
Active Alarm table because the table was full.
Part of the NAT traversal mechanism. If the STUN application
detects a NAT, this trap is sent on regular time laps - 9/10 of the
acSysSTUNBindingLifeTime object. The AdditionalInfo1 varbind
has the MAC address of the gateway.
373

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the V7122 and is the answer not in the manual?

Table of Contents