3Com V7122 User Manual page 197

ini File Field Name
Web Parameter Name
RTPOnlyMode
Profile Parameters
CoderName_ID
V7122 Gateway User Guide
Valid Range and Description
Enables the gateway to start sending and/or receiving RTP packets to and
from remote endpoints without the need to establish a Control session. The
remote IP address is determined according to the Tel2IP Routing table.
The port is the same port as the local RTP port (set by BaseUDPPort and
the channel on which the call was received).
Valid options include:
0 = Disable (default).
1 = Transmit & Receive.
2 = Transmit Only.
3 = Receive Only.
Defines groups of coders that can be associated with IP or Tel profiles (up
to five coders in each group).
Enter coder groups in the following format:
CoderName_<coder group ID from 1 to 4>=<Coder
Name>,<Ptime>,<Rate>,<Payload Type>,<Silence Suppression Mode>.
Packetization
Coder Name
Time
G.711 A-law 10, 20 (default),
[g711Alaw64k] 30, 40, 50, 60,
80, 100, 120
G.711 μ-law 10, 20 (default),
30, 40, 50, 60,
[g711Ulaw64k]
80, 100, 120
G.729 10, 20 (default),
[g729] 30, 40, 50, 60,
80, 100
G.723.1 30 (default), 60,
[g7231] 90, 120
G.726 10, 20 (default),
[g726] 30, 40, 50, 60,
80, 100, 120
GSM-FR 20 (default), 40,
[gsmFullRate] 60, 80
GSM-EFR 10, 20 (default),
[gsmEnhancedFullR 30, 40, 50, 60,
ate] 80, 100
MS-GSM 40 (default)
[gsmMS]
Payload Silence
Rate
Type Suppression
Always Always 8 Disable [0]
64 Enable [1]
Always Always 0 Disable [0]
64 Enable [1]
Always Always Disable [0]
8 18 Enable [1]
Enable w/o
Adaptations
[2]
5.3 [0], Always 4 Disable [0]
6.3 [1] Enable [1]
(default)
16 [0], Dynamic Disable [0]
24 [1], (0-120) Enable [1]
32 [2]
(default)
, 40 [3]
Always Always 3 Disable [0]
13 Enable [1]
12.2 Dynamic Disable [0]
(0-120) Enable [1]
Always Always 3 Disable [0]
13 Enable [1]
197