3Com V7122 User Manual page 157

ini File Field Name
Web Parameter Name
PPPoEUserName
PPPoEPassword
PPPoEServerName
PPPoEStaticIPAddress
PPPoERecoverIPAddress
PPPoERecoverSubnetMask
PPPoERecoverDfgwAddress
PPPoELCPEchoEnable
V7122 Gateway User Guide
Valid Range and Description
User Name for PAP or Host Name for CHAP authentication.
The valid range is a string of up to 47 characters. The default
value is 0.
Password for PAP or Secret for CHAP authentication.
The valid range is a string of up to 47 characters. The default
value is 0.
Server Name for CHAP authentication.
The valid range is a string of up to 47 characters. The default
value is 0.
IP address to use in a static configuration setup. If set, used
during PPP negotiation to request this specific IP address
from the PPP server. If approved by the server, this IP
address is used during the session.
The valid IP address range is in dotted notation
xxx.xxx.xxx.xxx. The default value is 0.0.0.0.
IP address to use when booting from the flash to non-PPPoE
(Point-to-Point Protocol over Ethernet) environments.
The valid IP address range is in dotted notation
xxx.xxx.xxx.xxx. The default value is 10.4.10.4.
Subnet Mask to use when booting from the flash to non-
PPPoE (Point-to-Point Protocol over Ethernet) environments.
The valid IP address range is in dotted notation
xxx.xxx.xxx.xxx. The default value is 255.255.0.0.
Default GW address to use when booting from the flash to
non-PPPoE (Point-to-Point Protocol over Ethernet)
environments.
The valid IP address range is in dotted notation
xxx.xxx.xxx.xxx. The default value is 10.4.10.1.
Enables or disables the Point-to-Point Protocol over Ethernet
(PPPoE) disconnection auto-detection feature.
Valid options include:
0 = Disable
1 = Enable (default)
By default, the PPPoE Client (that is, embedded in the
gateway) sends LCP Echo packets to the server to check
that the PPPoE connection is open. Some Access
Concentrators (PPPoE servers) don't reply to these LCP
Echo requests, resulting in a disconnection. By disabling the
LCP disconnection auto-detection feature, the PPPoE Client
doesn't send LCP Echo packets to the server (and does not
detect PPPoE disconnections).
157