Security Settings - 3Com V7122 User Manual

•
Saving a configuration file to flash memory may disrupt traffic on the
gateway. To avoid this, perform a graceful lock (see
the Gateway
•
A device reset is required to activate a loaded CPT file.

Security Settings

From the Security Settings you can:
Configure the Web User Accounts (see
Configure the Web & Telnet Access List (see
List).
Configure the Firewall Settings (see
Configure the Certificates (see
Configure the General Security Settings.
Configure the IPSec Table (see
Configure the IKE Table (see
Configuring the Web User Accounts
To prevent unauthorized access to the Embedded Web Server, two user accounts are
available, a primary and secondary. Each account is composed of three attributes:
username, password and access level. For detailed information on the user account
mechanism, see User
It is recommended that you change the default username and password of the account you
use to access the Embedded Web Server.
To change the Web User Accounts attributes:
Open the 'Web User Accounts' screen (Advanced Configuration menu > Security
1
Settings > Web User Accounts option); the 'Web User Accounts' screen is displayed.
116
) on all traffic on the device before saving to flash memory.
Configuring the Web User
Configuring the Firewall
Configuring the
IPSec Configuration).
IKE Configuration).
Accounts.
Locking and Unlocking
Accounts).
Configuring the Web and Telnet Access
Settings).
Certificates).
V7122 GatewayUser Guide