3Com V7122 User Manual page 163

ini File Field Name
Web Parameter Name
EnableSilenceDisconnect
[Disconnect Call on Silence
Detection]
FarEndDisconnectSilence
Period
[Silence Detection Period]
FarEndDisconnectSilence
Method
[Silence Detection Method]
FarEndDisconnectSilence
Threshold
Automatic Update Parameters
CmpFileURL
V7122 Gateway User Guide
Valid Range and Description
1 = The gateway disconnect calls in which silence occurs in both (call)
directions for more than 120 seconds.
0 = Call is not disconnected when silence is detected (default).
The silence duration can be set by the 'FarEndDisconnectSilencePeriod'
parameter (default 120).
To activate this feature set: 'EnableSilenceCompression' to 1 and
'FarEndDisconnectSilenceMethod' to 1.
Duration of silence period (in seconds) prior to call disconnection.
The range is 10 to 28800 (8 hours). The default is 120 seconds.
Applicable to gateways, that use DSP templates 2 or 3.
Silence detection method.
0 (None) = Silence detection option is disabled.
1 (Packets Count) = According to packet count.
2 (Voice/Energy Detectors) = N/A.
3 (All) = N/A.
Threshold of the packet count (in percents), below which is considered
silence by the media gateway.
The valid range is 1 to 100. The default is 8%.
Applicable only if silence is detected according to packet count
(FarEndDisconnectSilenceMethod = 1).
Specifies the name of the cmp file and the location of the server (IP address
or FQDN) from which the gateway loads a new cmp file and updates itself.
The cmp file can be loaded using: TFTP, HTTP, HTTPS, FTP, FTPS or NFS.
For example: http://192.168.0.1/filename
When this parameter is set in the ini file, the gateway always
loads the cmp file after it is reset.
The cmp file is validated before it is burned to flash. The
checksum of the cmp file is also compared to the previously-
burnt checksum to avoid unnecessary resets.
The maximum length of the URL address is 99 characters.
163