3Com V7122 User Manual page 87

group can be configured). For information on how to enable this option, see
the Trunk Group Settings. If a Channel Select Mode for a specific trunk group isn't
specified, then the global 'Channel Select Mode' parameter (defined in 'General
Parameters' screen under 'Advanced Parameters') applies.
To configure the IP to Trunk Group Routing table:
Open the 'IP to Trunk Group Routing' screen (Protocol Management menu > Routing
1
Tables submenu > IP to Trunk Group Routing option); the 'IP to Trunk Group Routing'
table screen is displayed.
IP to Trunk Group Routing Table
Figure 29
In the 'IP to Tel Routing Mode' field, select the IP to Tel routing mode (see
2
In the 'Routing Index' drop-down list, select the range of entries that you want to edit (up
3
to 24 entries can be configured).
Configure the IP to Trunk Group Routing table according to
4
Click the Submit button to save your changes.
5
To save the changes so they are available after a power fail, see
6
V7122 Gateway User Guide
Configuring
Table 44).
Table 25.
Saving Configuration.
87