3Com V7122 User Manual page 341

Parameter Name
First to Fourth Proposal
Encryption Type
[IPSecPolicyProposalEncrypt
ion_X]
First to Fourth Proposal
Authentication Type
[IPSecPolicyProposalAuthen
tication_X]
If no IPSec methods are defined (Encryption / Authentication), the default settings (shown in
Table 71) are applied.
Default IKE Second Phase Proposals
Table 71
Proposal 0
Proposal 1
Proposal 2
Proposal 3
To configure the SPD table using the ini file:
SPD table is configured using ini file tables (described in
in the table refers to a different IP destination.
The Format line (SPD_INDEX in the example below) specifies the order in which the actual
data lines are written. The order of the parameters is irrelevant. Parameters are not
mandatory unless stated otherwise. To support more than one Encryption / Authentication
proposals, for each proposal specify the relevant parameters in the Format line. Note that the
proposal list must be contiguous.
V7122 Gateway User Guide
Description
Determines the encryption type used in the quick mode negotiation for up to
four proposals.
X stands for the proposal number (0 to 3).
The valid encryption values are:
Not Defined (default)
None [0] = No encryption
DES-CBC [1]
Triple DES-CBC [2]
AES [3]
Determines the authentication protocol used in the quick mode negotiation
for up to four proposals.
X stands for the proposal number (0 to 3).
The valid authentication values are:
Not Defined (default)
HMAC-SHA-1-96 [2]
HMAC-MD5-96 [4]
Encryption
3DES
3DES
DES
DES
Authentication
SHA1
MD5
SHA1
MD5
Using Parameter Tables). Each line
341