3Com V7122 User Manual page 228

ini File Field Name
Web Parameter Name
DigitMapping
[Digit Mapping Rules]
TimeBetweenDigits
[Inter Digit Timeout for
Overlap Dial]
MaxDigits
[Max Digits In Phone Num
for Overlap Dialing]
TimeForDialTone
SendMetering2IP
[Send Metering Message to
IP]
R2Category
[MFC R2 Category]
228
Valid Range and Description
Digit map pattern (used to reduce the dialing period when Overlap dialing is
used). If the digit string (dialed number) has matched one of the patterns in
the digit map, the gateway stops collecting digits and starts to establish a
call with the collected number.
The digit map pattern contains up to 52 options separated by a vertical bar
(|) and enclosed in parenthesis.
The maximum length of the entire digit pattern is limited to 152 characters.
Available notations:
[n-m] represents a range of numbers
'.' (single dot) represents repetition
'x' represents any single digit
'T' represents a dial timer (configured by TimeBetweenDigits parameter)
'S' should be used when a specific rule, that is part of a general rule, is
to be applied immediately. For example, if you enter the general rule x.T
and the specific rule 11x, you should append 'S' to the specific rule
11xS.
For example: (11xS|00T|[1-
7]xxx|8xxxxxxx|#xxxxxxx|*xx|91xxxxxxxxxx|9011x.T)
The digitmap mechanism is applicable only when ISDN Overlap
dialing is used (ISDNRxOverlap = 1).
Defines the time (in seconds) that the gateway waits between digits that are
received from the ISDN when Tel IP overlap dialing is performed. When
this inter-digit timeout expires, the gateway uses the collected digits for the
called destination number.
The range is 1 to 10 seconds. The default value is 4 seconds.
Defines the maximum number of collected destination number digits
received from the ISDN when Tel IP overlap dialing is performed. When
the number of collected digits reaches the maximum, the gateway uses
these digits for the called destination number.
The range is 1 to 49. The default value is 30.
Duration (in seconds) of the dial tone played to an ISDN terminal.
Applicable to overlap dialing when 'ISDNInCallsBehavior = 65536'. The dial
tone is played if the ISDN Setup message doesn't include the called
number.
The valid range is 0 to 60. The default time is 5 seconds.
Enables or disables sending a metering tone INFO message to IP on
detection of an MFC\R2 metering pulse.
Valid options include:
0 = Disable (default).
1 = Enable.
MFC R2 Calling Party Category (CPC). The parameter provides information
on calling party such as National or International call, Operator or Subscriber
and Subscriber priority. The parameter range is 1 to 15, defining one of the
MFC R2 tones.
V7122 GatewayUser Guide