To Specify Desired Paper Size (Ams) - Konica Minolta 7045 Instruction Manual

Selecting Paper Size (continued)
I To Specify Desired Paper Size (AMS)
When a paper size is specified on the touch screen, an
appropriate ratio will be selected automatically accord-
ing to the original size detected from the RADF or the
platen glass.
1
Touch a tray key on the Basic Screen
to select the desired paper size.
Selected tray key will be highlighted, and
under the LENS indication will also be highlighted.
2
Select additional copy conditions, as
desired.
3
Enter the desired print quantity from
the control panel keypad.
4
Position original(s).
5
Press
START
Scanned image will be printed on the specified
paper size in the magnification ratio automatically
selected.
.
HINTS
See the table on the following
page for the relation of origi-
nal size, copy paper size, and
magnification ratio automati-
cally selected.
HINTS
If copying in 1.00 (100%) mag-
nification mode with specify-
ing a paper size is desired,
see p. 3-11.
–A–
HINTS
See p. 3-6 for details on set-
ting print quantity.
HINTS
• See p. 9-5 to p. 9-6 for pa-
per sizes detectable from
the RADF or on the platen
glass.
• See p. 3-2 to p. 3-5 for de-
tails on positioning originals.
Copy result may not be satis-
factory due to the Rotation
function. In this case, set the
function OFF manually. See.
p. 7-9 to p. 7-10.
3
Copying
Operations
Positioning
Originals
Setting
Print Quantity
Paper Size
Lens Mode
Density
1s2, 2s2
2s1
Using
Memory
Output without
Finisher
FS-109
Output Modes
Check Mode
& Proof Copy
Interrupt
Mode
3-9