Entering An Ekc Password (Ekc) - Konica Minolta 7022 Instruction Manual

Entering an EKC Password (EKC)

The Electronic Copy Monitor (EKC) allows the Key Operator to monitor all copying
activities by controlling EKC password accounts. Copy quantity limits for specific
accounts can be set.
The EKC is not factory-set. An EKC password is required only when the EKC is
activated, a User Password is assigned, and "Enter E.K.C. password" is displayed on
the touch screen.
Copying will be available by following procedure:
1.
Enter EKC password.
Enter your 8-digit EKC password, using the keypad.
2.
Press [START].
Your current copy count and copy limit will be displayed for 3 sec.
Current count / limit
018888/025000
3.
Start a copying job.
When the message changes to "Ready to copy," copying job is available on the
machine.
4.
Press [✽] while pressing [#].
The initial state will be restored, with the message "Enter E.K.C. password" displayed
on the screen.
2-14
Turning On the Power Switch (continued)
HINT
For details of the EKC setting, see p. 11-18 to p. 11-26.
HINT
For setting an EKC password, see p. 11-20 to p. 11-21.
DETAILS
If an invalid EKC password is entered, continue by entering the correct
password.
DETAILS
When your copy count reaches the copy limit, the message "Copy limit
reached" will be displayed. In that case, contact the Key Operator to reset
your copy limit.