Unload An Open-Reel Tape - Xerox DocuPrint 96 Operator's Manual

OFFLINE PRINTING TASKS

Unload an open-reel tape

Place the tape drive offline
6-8
Before unloading a tape, ensure that the LPS system is not
accessing the open-reel tape drive, to avoid loss of data. The tape
drive should be offline and the message display should read "Ready"
before you remove a tape.
Note: You can also rewind and/or unload a tape using the system
controller terminal. For instructions, refer to the "Rewind/unload tape"
section later in this chapter.
To take the open-reel tape drive offline, press the Reset button, or the
Diag button if you are in Diagnostic mode (see figure 6-12).
Figure 6-12. Reset and Diag buttons
To unload a tape from the 9-track magnetic tape drive:
Step 1. When "Offline" appears on the message display, press and hold
the Reset button and the Rwd/Unl button (see figure 6-13).
Figure 6-13. Reset and Rwd/Unl buttons
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE