Xerox DocuPrint 96 Operator's Manual page 131

Laser printing system
Hide thumbs Also See for DocuPrint 96:
Table of Contents

Advertisement

System version
Attention Light/Alarm
Attention Light/Alarm task
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
Use this task to display the system version number, the disk ID, and
the current logon level.
System Version
Enter the following command:
OCS
Note: The Dialog versions do not appear when you enter this
command.
Use this task to enable or disable the Attention light and/or alarm.
The Attention light can be enabled or disabled for either or both
modes—steady and flashing. If, for example, you disable the steady
mode of the Attention light, but leave the flashing mode enabled, the
Attention light does not go on when a condition such as low dry ink
occurs (and the corresponding Hint icon does not appear on the
printer control console), but the Attention light still flashes when the
printer stops due to a fault (and the corresponding Fault icon still
appears on the printer control console).
To enable the Attention light, enter the following command:
ATTENTION LIGHT ENABLE [STEADY | FLASHING]
Table 3-1 lists each parameter and its description.
Table 3-1.
Parameter
STEADY
FLASHING
To disable the Attention light, enter the following command:
ATTENTION LIGHT DISABLE [STEADY | FLASHING]
Table 3-2 lists each parameter and its description.
Table 3-2.
Parameter
STEADY
FLASHING
To enable the alarm, enter the following command:
ATTENTION LIGHT ENABLE command parameters
and descriptions
Description
Enables only the steady mode of the Attention
light.
Enables only the flashing mode of the Attention
light.
ATTENTION LIGHT DISABLE command
parameters and descriptions
Description
Disables only the steady mode of the Attention
light.
Disables only the flashing mode of the Attention
light.
SYSTEM CONTROL TASKS
3-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Docuprint 96mx

Table of Contents