Xerox DocuPrint 96 Operator's Manual page 356

MAINTENANCE TASKS
Installing the custom transfer assist blade
Setting tray size with the custom transfer assist blades
10-22
Caution: For the above paper sizes, the standard transfer assist
blade must be used.
Caution: To avoid damage to the photoreceptor, you must perform
the Set Tray Size task explained in the "Status and print tasks"
chapter.
The custom transfer assist blade comes in a package containing
detailed instructions. Be sure to follow the instructions carefully.
Caution: To prevent damage to the LPS, have your service
representative show you the procedure before you attempt to
customize and install a custom transfer assist blade for the first time.
When you are using the custom transfer assist blade, you must set
the tray length differently than described in the "Set tray size" section
of the "Status and print tasks" chapter. Use tables 10-1 and 10-2 to
determine the tray length setting to use.
Table 10-1. Tray length settings for custom transfer assist
blades (U.S. markets)
Paper size
11.5 to 11.7 inches/292 to 297 mm
12.1 to 12.9 inches/307 to 328 mm
13 to 13.9 inches/330 to 353 mm
Table 10-2. Tray length settings for custom transfer assist
blades (Non-U.S. markets)
Paper size
10 to 10.9 inches/254 to 277 mm
11.5 to 11.6 inches/292 to 294 mm
12.1 to 12.9 inches/307 to 328 mm
Note: Set the tray width to the width of the custom paper.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
Set tray size to...
11.7 inches/297 mm
13 inches/330 mm
14 inches/356 mm
Set tray size to...
11 inches/279 mm
11.7 inches/297 mm
13 inches/330 mm