PAPER FACTS
Stacker bins
Paper
Superior performance
Size range
8 by 10 to 11.69 by 17
inches/203 by 254 to 297
by 432 mm
Weight range 20 to 110 pounds/80 to
200 gsm
Capacity
•
Stack quality
•
•
•
Type or
condition
•
•
2-16
The Xerox DocuPrint 96/DocuPrint 96MX LPS has one high-capacity
stacker (HCS) bin.
•
You can not lower, pull out, and unload the bin without
interrupting printing.
•
If you select the bin that is in use printing stops.
•
Once a sheet is delivered to the stacker bin, each subsequent
sheet must be within 25 mm of each dimension of the first
sheet.
Refer to table 2-6 for additional information on performance of the
high-capacity stacker bins.
Table 2-6.
Good performance
Lighter than 20 pounds/80
gsm and no lighter than 16
pounds/60 gsm
•
Xerographic paper in
good condition
•
20 pound/80 gsm and
heavier stock
Very low to no output
curl
•
Xerographic paper in
good condition
Predrilled stock
•
No cut-outs,
perforated or
intermixed weights
Stacker bin performance guide
Performance limits and
suggested alternatives
Smaller or larger sizes cannot be
used.
Weights outside the limits shown
here are not recommended.
•
•
•
Lighter weight stocks
with low output curl
•
Intermixed stocks
•
•
Labels, preprinted
forms, perforated
stocks
•
Intermixed weights
•
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
Capacity automatically
limited so stack weight will
not exceed 30 lbs/13.g kg
Selectable with bin capacity
programming (Refer to the
"Bin full criteria and setting
bin limits" section of the
"Status and print tasks"
chapter for instructions.
Adjust process decurler
Flip paper in paper feeders
Limit stack capacity to
acceptable limits.
High output curl stocks can
cause severe stack quality
problems
Tab stock intermixed with
smaller stocks results in
degraded stack quality
Reinforced mylar should be
limited to small stacks of 200
sheets or less or sent to the
sample tray