PROBLEM SOLVING TASKS
Incorrect paper size message
Stacker bin problems
Papers are being thrown around the stacker
Paper stack is falling over or sliding around the bin
System controller problems
11-26
If printing stops and a message appears on the printer control
console telling you that an incorrect paper size is loaded in a feeder
tray, check the paper in the indicated tray. If the paper is not the
correct size for the job, either load the correct size paper or select
another feeder tray containing the correct size paper. If the paper
size is correct, press the Continue button to resume printing. The
message may have been caused by a damaged sheet.
Note: In order to assure good print quality for your jobs, the LPS
automatically purges any dog-eared or skewed sheets of paper.
When the LPS encounters paper in this condition, it may stop printing
and issue an incorrect paper size message.
This section explains what to do when papers are being thrown
around the stacker, and when paper stack is falling over or sliding
around the bin.
This problem may occur when you have unloaded paper by opening
the top cover of the stacker bin.
Note: Never unload paper this way.
To remedy this situation, unload the bin following the normal
procedure. (Refer to the "Unloading a stacker bin" section of the
"Paper facts" chapter.)
This problem may be due to excessive paper curl. Try the following
remedies:
•
Reduce the paper curl by following the instructions in the
"Paper curl and paper jams" section of this chapter.
•
Reduce the number of sheets going to the bin through the Bin
Limits task. (Refer to the "Status and print tasks" chapter for
instructions.)
This section explains what to do when one of the following problems
occur:
•
LPS does not boot
•
Printer does not respond to the system controller
•
Blank display on the system controller terminal
•
Rasterization messages appear on the system controller
display
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE