Xerox DocuPrint 96 Operator's Manual page 460

METER READING AND REPORTING
Reviewing and changing data
A-8
Step 7. The system's next message is to ask you for a machine serial
number. At this point you have the following choices:
•
If you have more machines to report, repeat the previous steps
until all machines have been reported.
•
If you have no more machines to report and you are sure of the
accuracy of the information, enter **91# to end the reporting
session. The system responds by indicating how many
machines were processed and accepted during this session.
"Readings for ___ machines accepted. Thank you for using the
Xerox Electronic Meter Reading System."
Note: If you would like to practice with an imaginary serial number
before entering your actual serial number and meter read, you can
use serial number X12377889 (which converts to *9212377889).
This serial number is only a demonstration serial number; it cannot
generate a bill. You may practice all procedures described in the
"Entering meter read information" section using this serial number.
To review and change data:
Step 1. To begin the review, enter **1#. The system reads the first serial
number.
Step 2. To accept the serial number and continue, enter #. The system then
reads back the A meter read.
Step 3. Continue the review by accepting with the # sign each time the entry
is read back correctly.
If an entry read back is incorrect, enter **4# to cancel the entry, and
reenter the correct information after the voice prompts you to do so.
Be sure to wait until the voice is finished before making entries.
Step 4. To end the review at any time, enter **2#. When the review is ended,
the system asks you to enter the # sign to acknowledge the entries
as complete. You may then choose to enter more machine
information or terminate the session. (Refer to step 6 in the previous
section.)
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE