Xerox DocuPrint 96 Operator's Manual page 97
Laser printing system
Hide thumbs
Also See for DocuPrint 96:
- Message manual (358 pages) ,
- Installation planning manual (116 pages) ,
- Forms creation manual (164 pages)
Table of Contents
Advertisement
Stock type
Tab stock
9-inch cover stock
110 pound/200 gsm
High-speed label stock
Letterhead
Manual two-sided (duplex)
prints
Textured paper
1. You can order a mylar reinforcement tray which allows a feeder tray to handle up to 500 sheets of this type of
stock. Contact your service representative for additional information.
Paper sizing and print jobs
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
Table 2-5.
Instructions for use
•
Load into trays 1 and 2 with tabs to the LEFT.
•
For best performance, print should be centered on the tab and should not
extend to either edge.
•
Use tab stock in perfectly flat condition. DO NOT use deformed, bent, or
damaged tabs.
Load into any tray.
•
Load FACE UP.
•
DO NOT run two-sided (duplex) prints.
•
Load into trays with side 1 UP and top edge toward the front of the tray
(avoid placing the print in line with the feed belt in trays 1 and 2).
•
Avoid using freshly preprinted paper.
•
Load into trays with printed side DOWN and top edge toward the front of the
tray (avoid placing the print in line with the feed belt in trays 1 and 2).
•
Print the second side as soon as possible after the first side to prevent
wrinkling and excessive curl.
Heavily textured paper may yield prints with ragged character appearance and/
or deletions. To test, print a sample sheet.
The Xerox DocuPrint 96/DocuPrint 96MX LPS feeder trays have
edge guide sensors that detect paper length and width. The LPS
selects the correct feeder tray(s) for the print job, based on the paper
size specified in the job.
•
If an exact match is found, the print job proceeds.
•
If an exact match is not found, depending on how the job was
set up, one of the following occurs:
— A message appears on the system controller display and
the printer control console telling you to load different
paper or inquiring whether it is permissible to print the job
on paper that is larger than specified for the job.
— The job prints on paper larger than specified for the job.
— The job is aborted.
Note: The LPS never prints a job on paper known to be
smaller than that specified for the job.
If you encounter any problems related to paper sizing, contact your
lead operator, systems specialist, or Xerox support specialist
Paper stocks guide (continued)
PAPER FACTS
2-7
Advertisement
Table of Contents
