Xerox DocuPrint 96 Operator's Manual page 307

REVIEW
RNAME
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
When no parameters are specified, the system defaults to all fonts
and all logos in the font and logo file catalogs.
Use this command to review each file in a directory with the option of
deleting it.
Syntax REVIEW [ disk-id ]{ file-id [, file-id ,...]}
Parameters Table 9-13 shows the syntax parameters of the REVIEW command.
Table 9-13. Parameters of the REVIEW command
Parameter
disk-id
file-id
After the operator requests the set of file names in a file type
displayed, the file names are displayed one at a time. The operator
has the option of deleting a file by entering D or exiting the display
process by entering the X command.
Any response other than D or X (for example pressing the space bar)
results in the current file being retained and the next file name being
displayed. Any file name containing a period or dollar sign cannot be
deleted and is displayed with the message *PROTECTED*.
Use this command to change the name and/or directory type of a file.
After the file name has been changed, the original name is deleted
from the file directory.
Syntax RNAME old-file-id new-file-id
If the file-type part of the new file-id is not specified, the file type is the
same as the old file. (Masking does not apply to this command.)
Description
Refers to the system disk (DP0:, DP1:, DP2:,
DP3:) that contains the specified directory.
Refers to the name of a file and the file directory in
which it resides. The form used is file-name.file-
type as previously defined. To delete a file from
the system, the operator must have an
appropriate level of access; refer to the Setting file
access and task execution privileges" section in
chapter 1. (Masking can be used for this
application.)
FILE CONTROL TASKS
9-13