Xerox DocuPrint 96 Operator's Manual page 223

Rewind/unload tape
Rewind/Unload Tape task
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
Table 6-1. START command parameters and descriptions
Parameter Description
TD n Specifies the tape device being used.
Notes:
1. The tape device identifications are set up
during sysgen. Refer to the Xerox DocuPrint 96/
DocuPrint 96MX LPS System Generation Guide
for additional information.
2. You cannot select a tape device when you
have selected DISC or FORM.
DISC: file- Indicates you want to print a file stored on the
name . filetype system disc.
FORM= Form- Indicates you want to print a form stored on the
name . Frm
system disc.
Example: STA 21,POWGRP,M,2,REPORTS:1,3-5,2 means start to
process or print from the JDE called 21, the JDL file called POWGRP,
in multiple report mode, two prints each of reports 1, 3-5, and 2.
The Rewind/Unload Tape task allows you to do the following from the
system controller terminal:
•
Rewind a tape to BOT
•
Rewind a tape and unload it from the take-up reel, clearing the
tape path.
To rewind a tape, enter the following command:
TAPE[CARTRIDGE | TD n ] REWIND
Table 6-2 lists the parameter and its description.
Table 6-2. TAPE command parameter and description
Parameter Description
TD n The tape drive you are using. (The tape device
identifications are set up during sysgen. Refer to
the Xerox DocuPrint 96/DocuPrint 96MX LPS
System Generation Guide for additional
information.)
To unload a tape, enter the following command:
TAPE[CARTRIDGE|TD n ] UNLOAD
Refer to table 6-2 for a description of the TD n parameter.
OFFLINE PRINTING TASKS
6-27