Xerox DocuPrint 96 Operator's Manual page 302

FILE CONTROL TASKS
Copy to/from floppy
Copy Floppy Disks task
9-8
Use this task to copy files from:
•
System disk to floppy disk
•
Floppy disk to system disk.
Note: This task is used for the optional floppy disk drive on the
system controller.
To format and initialize a floppy disk, enter the following command:
FLOPPY FORMAT
Refer to your Xerox DocuPrint 96/DocuPrint 96MX LPS Operations
Reference for additional information.
To copy files from the system disk to a floppy disk, enter the following
command:
FLOPPY SAVE [REVIEW] [ disk-id ] { input-file-id | output-file-id
| file-id | file-type | ALL}
Table 9-6 lists each parameter and its description.
Table 9-6.
Parameter
REVIEW
disk-id
input-file-id | output-
file-id | file-id | file-type
ALL
To copy files from a floppy disk to the system disk, enter the following
command:
FLOPPY RESTORE [REVIEW] [ disk-id ] { input-file-id | output-
file-id | file-id | file-type | ALL}
FLOPPY SAVE command parameters and
descriptions
Description
Prompts you to confirm or stop overwriting a floppy file by
a system file. If you enter N, the file is not copied to floppy
disk, and the save process skips to the next file on the
system disk.
The system disk unit containing the files to be saved. If you
do not specify a disk id, all disks are searched.
The identity of the input and output files.
Saves all user files on the floppy disk.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE