Xerox DocuPrint 96 Operator's Manual page 78

PAPER FACTS
2-10
Step 4. Load paper, following the instructions on the label at the front top of
the feeder tray. Figure 2-4 shows the location of these instructions.
Figure 2-4. Paper loading instructions
Note: Load transparencies and 9-inch/229-mm tabs into one
of the processor feeder trays only.
Remember the following:
•
Remove any damaged sheets.
•
Load the paper with the package wrapper seam side up.
•
For tray 3 only, load paper with curl side up if paper curl is
detected. If no paper curl is detected, load paper with the
wrapper seam side down.
•
If using tab stock, remove any deformed, bent, or damaged
stock.
•
If using predrilled paper, fan thoroughly and remove any loose
paper plugs
•
Ensure the paper is loaded into the front, right corner of the
tray, as indicated by the green arrow on the bottom of the tray
and by the arrows on the instruction label (see figure 2-5).
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE