Sample Files - Xerox DocuPrint 96 Operator's Manual

Sample files

Sample Files task
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
Use this task to print samples of fonts, forms, logos, or graphics.
To print a sample of a form, font, logo, or graphic stored on the
system disk, enter the following command:
SAMPLE file-name . file-type [,D, copies ]
Table 4-5 lists each parameter and its description.
Table 4-5. SAMPLE command parameters and descriptions
Parameter Description
file-name The name of the file, obtained from your systems
personnel.
file-type One of the following:
•
.FRM (form)
•
.FNT (font)
•
.IMG (graphic)
D Print the samples on both sides of each sheet of
paper (duplex mode). If you do not enter a D, the
samples print on only one side of each sheet of
paper (simplex mode).
copies
The number of copies you want. If you do not
enter a number, one copy is printed.
Note: For prints of graphics only, you may be asked to use the
HARDCOPY command instead of the SAMPLE command. There is
no difference in the graphic, but the data sheet that is printed with it
is more detailed when the HARDCOPY command is used.
To print samples of all files of a certain type, such as font, form, and
logo files, specify the type only. Enter the following command:
SAMPLE . file-type [,D, copies ]
Table 4-6 lists each parameter and its description.
Table 4-6. SAMPLE command parameters and descriptions
Parameter Description
file-type One of the following:
•
.FRM (form)
•
.FNT (font)
•
.IMG (graphic)
D Print the samples on both sides of each sheet of
paper (duplex mode). If you do not enter a D, the
samples print on only one side of each sheet of
paper (simplex mode).
copies
The number of copies you want. If you do not
enter a number, one copy is printed.
JOB CONTROL TASKS
4-9