Xerox DocuPrint 96 Operator's Manual page 264

STATUS AND PRINT TASKS
Printer Status task
IOT State:
Current feed mode:
Current select mode:
Tray:
1
2
3
Bin:
A
Select feeder trays
Select Feeder Trays task
8-4
Note the following:
•
•
Enter the following command:
PSTATUS
The selection and status information appears on the screen. Figure
8-1 shows an example of HIP job status display.
Figure 8-1.
feed mode
select mode
Status: Paper level:
Selected 1/2 full
Ready Full
Ready Full
Status: Paper level:
Selected 1/2 full
Use this task to override stock selections in the print job and force
printing of a job using a specific tray, cluster, or a feeding device.
To use the clusters set up in the print job, enter the following
command:
FEED MAIN
To feed paper from the Aux cluster, enter the following command:
FEED AUX
To feed paper from all trays, enter the following command:
FEED AUTO
To feed paper using a specific cluster, enter the following command:
FEED cluster name
cluster name is the name of the cluster you want to use.
To feed paper from a specific tray, enter the following command:
FEED tray number
tray number is the number of the tray you want to use.
To feed paper from a bulk feeder, enter the following command:
FEED 7
You can display printer status by pressing the <PRINTER
STATUS> key.
The printer control console also provides a mimic of the printer
showing some of the same information specified in this section.
Example of HIP job status display
Client-layer:
Paper size:
11.5 by 8.0
11.5 by 8.0
11.5 by 8.0
Paper size:
8.5 by 11.00
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE