Xerox DocuPrint 96 Operator's Manual page 74

PAPER FACTS
Stock type
16 pound/60 gsm paper
20 pound/80 gsm paper
65 pound card stock
110 pound/200 gsm paper
(index)
20 pound or 80 gsm dual-
purpose
3-hole drilled
4-hole drilled
7-hole drilled
Non-tearing 3-hole
Non-tearing
Xerox carbonless paper
3-hole drilled, edge
reinforced dual-purpose
Transparencies—
Oversized (8.5 by 14 inches,
0.5 inch white stripe/216 by
356 mm, 1 mm white strip)
Preprinted stock
Transparencies—
Paper-backed,
high-speed,
removable stripe
2-6
Table 2-5.
Instructions for use
•
Load paper with ream wrapper seam side down. If there is no arrow on the
ream wrapper, load paper in tray 3 with curl up.
•
Duplexing 16 lb. paper is not recommended.
•
Best performance can be expected from tray 3.
Load paper with ream wrapper seam down. If there is no arrow on the ream
wrapper, load paper in tray 3 with curl up.
Run from any tray.
•
Load with holes to the RIGHT.
•
Use the Align task to avoid printing near the holes.
•
Fan paper thoroughly and check for loose paper plugs prior to loading.
•
Load in trays 1 and 2 only.
•
Load with holes to the RIGHT.
•
DO NOT run two-sided (duplex) prints.
•
Load in trays 1 and 2 only.
•
DO NOT run two-sided (duplex) prints.
•
Load paper in tray 3 only.
•
Only Xerox carbonless paper is recommended for High speed Xerographic
equipment.
•
Use trays 1 and 2.
•
Load paper with holes to the right, reinforced side DOWN.
•
In two-sided (duplex) printing, degraded print quality may occur near the
reinforcement.
•
Leave stock in wrapper until use to achieve maximum stock flatness.
•
Run with no more than 200 sheets in a tray.
•
Load with the white stripe to the RIGHT in trays 1 and 2 ("shiny" side UP for
best performance).
•
Simplex only.
Certain types of ink or insufficient drying time may cause the ink to adhere to
various machine components and printed sheets. Allow at least 3 hours of drying
time before using preprinted stock.
CAUTION: Certain preprinted stocks lie unevenly in the feeder trays. If the right
side of the stack is higher than the left in tray 3 SEVERE hardware damage can
occur. Load the stock in trays 1 or 2 or load fewer sheets.
•
High-speed paper-backed transparencies may be run from trays 1 and 2
with paper side DOWN.
•
Run no more than 50 removable stripe transparencies at one time.
•
Load the transparencies on top of approximately 50 sheets of paper.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
Paper stocks guide
1