Tray Loading; Clusters - Xerox DocuPrint 96 Operator's Manual

STATUS AND PRINT TASKS

Tray loading

Tray Loading task

Clusters

8-6
Use the Tray Loading task to respond to system messages
concerning stockset problems for the current print job.
Perform the following steps:
Step 1. When a print job calls for a stock change, the existing clusters appear
on the system controller display. The current trays field is blank for
undefined clusters.
Refer to the following example.
BLUE ASIZ
GREEN ASIZ
Step 2. Load the correct stock in the correct trays.
Step 3. To define the current trays for the undefined cluster, enter the
following command:
CLUSTER cl-name tray number
Table 8-1 lists each parameter and its description.
Table 8-1.
Parameter
cl-name
tray number
Use the Clusters task to:
•
Display all the clusters in the system with their preferred and
current trays
•
Define new clusters
•
Edit preferred or current trays for existing clusters.
Note: You must define tray contents to the LPS when you
change the stock in a tray being used by the current stockset
without being prompted by the system to change the stock in
that tray.
Clusters task To display all clusters in the system, enter the following command:
CLUSTER
----PREFER--- ----CURRENT---
1 3
---PREFER--- ---CURRENT---
2
CLUSTER command parameters and descriptions
Description
Disables only the steady mode of the Attention
light.
The tray(s) in which stock for the cluster is
currently loaded.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
---STATUS---
1 3 HAS TRAYS
---STATUS---
IS DEFINED