Xerox DocuPrint 96 Operator's Manual page 265

Select stacker bins
Select Stacker Bins task
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
Use this task to select the bin(s) used for stacking printed pages. You
can also select the sample tray or a finishing device as the output
destination.
The stacking order default is AUTOMODE, which specifies that
Stacker A is to be used.
If you specify a different stacking order through this task:
•
If the LPS is printing, the output goes to the selected bin (unless
it is full).
•
When the selected bin is full, the LPS sends output to the next
empty bin that can accept the paper size.
•
If no bin is available that can accept the paper size, the printer
stops and you must unload the bin(s).
•
If you select the sample tray, all printed pages are delivered
there until the report ends or you change the stacker bin
selection.
To select the AUTOMODE stacking order, enter the following
command:
SELECT AUTO
To select the sample tray, enter the following command:
SELECT TRAY
To select Stacker A, enter the following command:
SELECT A
STATUS AND PRINT TASKS
8-5