Xerox DocuPrint 96 Operator's Manual page 61

Attention light
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
SYSTEM OVERVIEW OF THE XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS
1. Continue button. Press this button to resume printing.
2. Stop button. Press this button to stop printing.
3. Sample button. Press this button to cause a sample of the
current print job to be sent to the sample tray.
4. Brightness control thumbwheel. Use this thumbwheel to
adjust the brightness of the printer control console display.
5. Language icon. If two languages are available for your printer
control console, selecting this icon allows you to choose the
language for the printer control console messages.
6. Clear button. Select this button to clear fault messages.
7. Printer icon. Select this icon to display the printer mimic. (This
is the default display on the printer control console.)
8. Tools icon. Select this icon to display call for service
information and to adjust display features of the printer control
console (for example, alarm loudness).
9. Fault List icon. Select this icon to display the Fault List screen.
Refer to the "Fault masking and the printer control console"
section of the "Problem solving tasks" chapter for additional
information on this screen.
10. Message area. This area is used as follows:
•
Lines 1 and 2. These lines display the current status of the
printer, for example, READY.
•
Line 3. This line displays messages concerning masked
conditions, such as low dry ink. These messages are
preceded by an asterisk.
•
Line 4. This line displays messages that originate at the
system controller.
11. Icons area. The following icons appear in this area:
Hint icon. This icon appears when a masked fault MT038 or a
condition exists in the printer. (Refer to the "Fault masking and the
printer control console" section of chapter 12, "Problem solving
tasks," for additional information.)
Fault icon. This icon appears when a fault exists in the system that
stops the printer or prevents it from printing.
An Attention light is mounted on top of the inverter feeder/stacker
module. (Refer to figure 1-5.) The Attention light can be enabled or
disabled (refer to chapter 4, "System control tasks," for instructions).
When enabled, the light has three states:
•
Off. No printer problems exist that require your attention.
•
Steady light. A situation exists that needs your attention (such
as low dry ink condition).
•
Flashing. The printer has stopped and your attention is
required immediately.
1-11