Unload An Open-Reel Tape - Xerox 4635 Operator's Manual

OFFLINE PRINTING TASKS

Unload an open-reel tape

Place the tape drive offline
7-8
Before unloading a tape, ensure that the LPS system is not
accessing the open-reel tape drive, to avoid loss of data. The
tape drive should be offline and the message display should read
"Ready" before you remove a tape.
Note: You can also rewind and/or unload a tape using the PC UI
or system controller terminal. For instructions, refer to the
"Rewind/unload tape" section later in this chapter.
To take the open-reel tape drive offline, press the Reset button
(or the Diag button if you are in Diagnostic mode).
Figure 7-12. Reset and Diag buttons
Follow this procedure to unload a tape from the 9-track magnetic
tape drive.
1. When "Offline" appears on the message display, press and
hold the Reset button and the Rwd/Unl button.
Figure 7-13. Reset and Rwd/Unl buttons
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE