Xerox DocuPrint 96 Operator's Manual page 355

Cleaning the 1/4 inch cartridge tape drive
Using the custom transfer assist blade
When not to use the custom transfer assist blade
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
The 1/4 inch cartridge tape drive heads should be cleaned at least
once a week. If you use the drive for eight hours or more per day,
then you should clean the drive daily. The process is simple and
requires very little time.
Step 1. If there is a cartridge in the tape drive, remove it.
Step 2. Insert the cleaning cartridge into the tape drive and close the door.
Cleaning begins automatically once the cartridge is inserted.
Step 3. Allow the tape to run for approximately 30 seconds, then remove it.
Note: Replace the foam pad on the cleaning cartridge after it has
been used three times. The cleaning cartridge itself can be used
approximately 100 times.
The transfer assist blade in the Xerox DocuPrint 96/DocuPrint 96MX
LPS assures good print quality for your jobs. A kit is available
allowing you to customize a transfer assist blade for use with non-
standard paper size.
Note: Use the custom transfer assist blade on all 4635MX systems
running non-standard paper sizes to ensure acceptable MICR line
quality.
You cannot use the custom transfer assist blade for print jobs that
use more than one paper size. In addition, the following range of
paper lengths cannot use the custom blade:
•
In U.S. markets
— 11.1 to 11.4 inches/282 to 290 mm
— 11.8 to 12.1 inches/300 to 307 mm
— 13 to 13.5 inches/330 to 343 mm.
•
In non-U.S. markets
— 11.1 inches to 11.4 inches/282 to 290 mm
— 11.8 inches to 12.1 inches/300 to 307 mm.
Note: With these paper sizes, transfer efficiency may be reduced.
MAINTENANCE TASKS
10-21