Xerox DocuPrint 96 Operator's Manual page 132

SYSTEM CONTROL TASKS
Turn off Attention light or alarm
Turn off Attention Light task
Energy saver
Energy Saver task
3-8
ATTENTION ALARM ENABLE {0-10}
0-10 Sets the tone volume for the alarm. 0 is softest, 10 is loudest
volume.
To disable the alarm, enter the following command:
ATTENTION ALARM DISABLE
Use this task to turn off the Attention light. Neither the steady nor
flashing modes of the Attention light operate, and the Hint and Fault
icons do not appear on the printer control console. When the next
fault condition occurs, the Attention light and appropriate icons
appear again.
Enter the following command:
ATTENTION ALL OFF
To conserve energy and prolong the life of some of its critical parts,
the LPS was designed with a power saver mode. After a
predetermined period of inactivity, portions of the printer are shut
down. The time-out period is factory set, but it can be readjusted.
Heating and cooling are the most costly uses of electricity. Therefore,
maintaining the system at full temperature while idle is not cost
effective. After four hours of inactivity (or whatever time period you
set), the fusing system shuts down. Once it cools down, it requires
the same four- to seven-minute warm-up time as if the system had
been turned off.
Use the Energy Saver task to readjust the time-out period. The
energy saver timer starts whenever the printer stops.
To adjust the time-out period, enter the following command:
ENERGY [ timeout ]
Table 3-3 lists the parameter and its description.
Table 3-3. ENERGY command parameter and description
Parameter Description
timeout The number of minutes after which the energy
saver mode begins. If you do not enter a value,
the current timeout value appears.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE