Power Off The Lps - Xerox DocuPrint 96 Operator's Manual

Power off the LPS

When LPS is in online mode
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
If no one is using the LPS for more than eight hours, power it off. For
idle times of less than eight hours, the LPS has a built-in energy
saver feature that can be adjusted to conserve energy and machine
parts. (Refer to the "Energy saver" section later in this chapter for
additional information.)
To power off the LPS if you are running online to a host computer:
Step 1. Contact the host system operator and request that the output from
the host to the LPS be drained and the LPS be varied offline at the
host.
Step 2. Press the <JOBS STATUS> key to ensure the system is idle (that is,
not processing print jobs or performing nonprinting tasks).
Step 3. If the job queue is not empty: Use either the Endjob or Drain tasks to
print any pages remaining in the print file. Press the <JOBS
STATUS> key again, to ensure the job queue is empty.
Step 4. Enter the OFFLINE command.
Step 5. Do one of the following:
•
Enter the CONTINUE I command.
•
Press the Continue button on the printer control console.
•
Press the <CON> key on the keyboard.
Caution: Failure to have the LPS offline prior to powering off
causes problems with the host system.
Step 6. When the LPS is offline, press the System Power Off button on the
operator control panel (see figure 3-3).
Figure 3-3. System Power Off button on operator control panel
SYSTEM CONTROL TASKS
3-3