Xerox DocuPrint 96 Operator's Manual page 154

JOB CONTROL TASKS
Print Darkness
Print Darkness task
4-6
Use this task to make the printed image lighter or darker. The setting
ranges from 1 (the lightest) to 9 (the darkest). The default value is 5.
Note: Turn off MICR mode when adjusting the DARKNESS
settings.
To change the print darkness level, enter the following command:
DARKNESS [ level [,TEST]]]
Table 4-2 lists each parameter and its description.
Table 4-2. DARKNESS command parameters and
descriptions
Parameter Description
level Print darkness level you want to apply.
TEST To receive a sample with the new darkness value
applied.
If a job is printing, a page with the new value applied is delivered to
the sample tray. If no job is printing, the test form with the new value
applied is delivered to the sample tray. (See figure 4-1.)
To display the current image darkness value, enter the following
command:
DARKNESS
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE