RRP 6-12 H-Tra Cover Open Sensor and Exit Path
Sensor (PL 20.3)
Figure 1
Fig 6-10 Sensors
Removal
1.
Open the top cover of the Horizontal Transport, remove the two screws and
remove the Cover Sensor Path . (Figure1)
2.
Remove the screw that secures the Top Cover Sensor to the Horizontal
Transport.
3.
Unhook the wire from the harness clamp.
4.
Unplug the connector (P/J261) of the Horizontal Transport Harness Assembly
(PL 20.2.24) from the Horizontal Transport Cover Open Sensor (PL 20.3.29).
5.
Unhook the Sensor at three places from the rear side of the Top Sensor, and
remove the Sensor.
6.
Unplug the connector (P/J263) of the Horizontal Transport Harness Assembly
from the Horizontal Transport Exit Sensor (PL 20.3.13).
7.
Unhook the Horizontal Transport Exit Sensor at four places from the right side
of the Horizontal Transport, and remove it.
Replacement
1.
Reverse the above procedure.
Figure 2
Volume 6 / Finisher - RRPs
S4525-432
6-725