Bootp Relay Commands - D-Link DES-3350SR Reference Manual

The BOOTP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config bootp_relay
config bootp_relay add
ipif
config bootp_relay
delete ipif
enable bootp_relay
disable bootp_relay
show bootp_relay
Each command is listed, in detail, in the following sections.
config bootp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To configure bootp relay status.
DES-3350SR Layer 3 Gigabit Switch
Parameters
{hops <value 1-16> | time <sec 0-65535>}
<ipif_name 12> <ipaddr>
<ipif_name 12> <ipaddr>
{ipif <ipif_name 12>}
Used to configure the BOOTP relay feature of the switch.
config bootp_relay {hops <value 1-16>} {time <sec 0-
65535>}
This command is used to configure the BOOTP relay feature.
hops <value 1-16>
agent hops that the BOOTP packets can cross.
time <sec 0-65535>
relay the BOOTP packet.
Only administrator-level users can issue this command.
local>config bootp_relay hops 4 time 2
Command: config bootp_relay hops 4 time 2
Success.
local>
BOOTP R
Specifies the maximum number of relay
If this time is exceeded, the switch will
181
29
C
ELAY OMMANDS